OK so I jetted the bike (97 kat 600) and now it's all back together and it won't start. I primed it for a few minutes and nothing, it just grinds like it wants to start but no kick. Once or twice it sputtered like it wanted to start but no start. (it started fine before the jet kit install, but I put slip ons on it last fall and it idle'd rough and missed ever since, the shop reccoimmended jetting it to fix this, so I installed a K&N air filter, and the jet kit the other day and now it won't start)
Also where should the idle be? I've played with it alot in the past, and since it's been jetted I don't know where to set it to. I thought I'd figure this out once it was running but since it won't turn over I'm wondering if this is part of the problem.
I installed the new needles and jets, and backed out the fuel/air mixture screw after drilling it out, I followed doug's instructions to a T, I also referenced Tre's page while doing the install as well, so I don't think I missed anything..
anybody have any ideas?
Also where should the idle be? I've played with it alot in the past, and since it's been jetted I don't know where to set it to. I thought I'd figure this out once it was running but since it won't turn over I'm wondering if this is part of the problem.
I installed the new needles and jets, and backed out the fuel/air mixture screw after drilling it out, I followed doug's instructions to a T, I also referenced Tre's page while doing the install as well, so I don't think I missed anything..
anybody have any ideas?
Comment