Just wondering if there's anything tricky about removing the front sprocket cover to get at the speedometer sensor nut.
My speedo is very wonky so I been searched around a bunch on here and have a similar problem as a few others I've seen. The sprocket cover is cracked right where the sensor mounts to it and when i removed the sensor today the nut underneath is loose. Something must have flung up there and jammed, cracking the cover and loosening the nut. I am hoping I can just take the cover off, and tighten the nut back onto the sprocket and I'll be good. If not there might be a new sprocket cover in my future.
I don't have a ton of tools here at my apartment, so I just need to know if i'm going to run into anything interesting. I know the clutch cable is mounted to the sprocket cover, can i just leave that intact and still get it off?
Thanks in advance!
My speedo is very wonky so I been searched around a bunch on here and have a similar problem as a few others I've seen. The sprocket cover is cracked right where the sensor mounts to it and when i removed the sensor today the nut underneath is loose. Something must have flung up there and jammed, cracking the cover and loosening the nut. I am hoping I can just take the cover off, and tighten the nut back onto the sprocket and I'll be good. If not there might be a new sprocket cover in my future.
I don't have a ton of tools here at my apartment, so I just need to know if i'm going to run into anything interesting. I know the clutch cable is mounted to the sprocket cover, can i just leave that intact and still get it off?
Thanks in advance!
Comment