Ad Widget

Collapse

Announcement

Collapse
No announcement yet.
X

Dead spot?

Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • bishop403
    started a topic Dead spot?

    Dead spot?

    I have an 02 750 kat and i noticed when i pull the throttle all the way back seems like the power is little better when i release the throttle forward abit.

    Is this a dead spot or is this normal?

    Also i was thinking of replacing the can only on this bike with a smaller can will i need to jet it?
    I will be using the orig header and mid pipe.
    Last edited by bishop403; 06-02-2009, 07:22 AM.

  • scottynoface
    replied
    Main jets are the wrong size, I agree with MD.

    Leave a comment:


  • Kattie
    replied
    Originally posted by bishop403 View Post
    I have an 02 750 kat and i noticed when i pull the throttle all the way back seems like the power is little better when i release the throttle forward abit.

    Is this a dead spot or is this normal?

    Also i was thinking of replacing the can only on this bike with a smaller can will i need to jet it?
    I will be using the orig header and mid pipe.

    My 90 kat is kind of like that...i noticed it pulls harder thru bottom end if u just roll into the throttle instead of just opening it wide open...but after u tach it up a bit it desnt matter it pulls great...lol...Do my carbs need adjusted..? bc thats what im thinkin.

    Leave a comment:


  • whitecl0ver
    replied
    take the K&N out

    Leave a comment:


  • md86
    replied
    Originally posted by JokerZwild View Post
    thats all in the needle right Md?
    More inclined to believe it's the mains , actually ...

    Leave a comment:


  • JokerZwild
    replied
    thats all in the needle right Md?

    Leave a comment:


  • md86
    replied
    Your jetting is likely off .

    Leave a comment:


  • bishop403
    replied
    Great!! thank you.

    Leave a comment:


  • DreKat
    replied
    if you keep the headers and mid pipe you wont need to adjust anything.

    Leave a comment:

Working...
X