As bad as I think? It was tough getting the slide guides out so this is the first I've ever seen of these emulsion tubes.
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
+1 , you're looking for the needle and tube to be as concentric as possible. You want a nice match there. Use an eye loupe or mag glass to look at the ID of the tube.
Also, make sure you check all the small ports on the emul tube to make sure there is no blockage. Soak in carb cleaner or clean with toothbrush bristles then blow out with canned air.1993 Kat 600 - (Parts bike)
1994 Kat 600 - Jardine full exhaust, Factory Pro Jet Kit, Pirelli Diablo Stradas, Fender CHOPPED, repainted plastics and tank
Comment
-
I've seen worse, but not by very much.
Look for a product at AutoZone or Advanced Auto Parts called "Barryman's Carb Dip" I think it's about $20 for a gallon bucket of the stuff. Just be careful not to get it on your clothes, or garage floor because it will stink.
It comes in a gallon pail, and should eat most of the crap off the tubes. Then you can inspect for an "egg shape" or clogged passages.-Steve
sigpic
Welcome to KatRiders.com! Click here to register
Don't forget to check the Wiki! http://katriders.com/wiki
Comment
Comment