Ok so I took the bike out this morning and she seemed to be running a little too lean. The rpm's would hang up around 3k after blipping the throttle and sometimes would take forever to fall below 2.5k. It rode fine, other than when I came to a stop the idle would sit around 2.5k for a while then drop down to 1200. I pulled the plugs and they were white as chalk, this is what they looked like, way lean if I'm not mistaken?
http://i719.photobucket.com/albums/w...k/Photo064.jpg (****ty I know but the only camera I have is my phone)
So I backed out the A/F screws 1/2 turn each and set my float height from 14mm to 13mm as per the directions in my factory pro kit to richen it up. I took her on another test run and this time, while in 2nd gear I'd give the throttle a good twist and she'd hesitate and then take off. It even died on me once and I had to choke it to get it started again. When I pulled the plugs after this run there was really no change in color. It seemed to run better the first time, but obviously was running way too lean...Is there something I'm missing here?
http://i719.photobucket.com/albums/w...k/Photo064.jpg (****ty I know but the only camera I have is my phone)
So I backed out the A/F screws 1/2 turn each and set my float height from 14mm to 13mm as per the directions in my factory pro kit to richen it up. I took her on another test run and this time, while in 2nd gear I'd give the throttle a good twist and she'd hesitate and then take off. It even died on me once and I had to choke it to get it started again. When I pulled the plugs after this run there was really no change in color. It seemed to run better the first time, but obviously was running way too lean...Is there something I'm missing here?
Comment