This may turn out to be a stupid question, but here goes.
How do the bar ends on a pre-98, specifically 88, Katana come off? Is the bar end itself threaded and need to be turned, or is there a screw going up the middle of the end? If its a screw, would it be allen head or torx or something besides a simple flat or phillips?
I've got new grips to go on my bike, and will be putting new bar ends on as well, so I'm not worried about damaging the old ones getting them off. Any help at all would be greatly appreciated.
How do the bar ends on a pre-98, specifically 88, Katana come off? Is the bar end itself threaded and need to be turned, or is there a screw going up the middle of the end? If its a screw, would it be allen head or torx or something besides a simple flat or phillips?
I've got new grips to go on my bike, and will be putting new bar ends on as well, so I'm not worried about damaging the old ones getting them off. Any help at all would be greatly appreciated.
Comment