Tweet
Hi,
did change my original jet kit against a factory pro stage 1 kit. When I changed out the needles the description says to reuse the white plastic washers under the metal ring.
When I took the stock needles out I noticed there where also very thin rubber o-rings between the metal ring and the plastic washer.
Now I did also switched them out but when I got to the #1 carb I did see that the thin rubber thing was a lot thicker almost like an o-ring from what goes by the vacuum connection. Just looked a lot thicker.
Should I remove all of them together? Or is that ok?
Thanks
did change my original jet kit against a factory pro stage 1 kit. When I changed out the needles the description says to reuse the white plastic washers under the metal ring.
When I took the stock needles out I noticed there where also very thin rubber o-rings between the metal ring and the plastic washer.
Now I did also switched them out but when I got to the #1 carb I did see that the thin rubber thing was a lot thicker almost like an o-ring from what goes by the vacuum connection. Just looked a lot thicker.
Should I remove all of them together? Or is that ok?
Thanks