i did this years ago and can't locate the original pictures of how i cut the fender but i needed to replace the turn signals so i took some new ones.
first off - i removed the fender ( you don't have to do this ) cut off all the plastic that hangs under the bodywork. i used a leather glove and a bic lighter to heat up and smooth the cut edge.
i cut out a bracket - spacings may vary depending on your states plate and the location & size of the turn signals used.
i cut out a hole in the fender & cut the licence plate light out of the removed section & mounted it.
seen from the bottom ( freshly washed )
mount the bracket
mounted the turn signals and plate
and at night
tim
first off - i removed the fender ( you don't have to do this ) cut off all the plastic that hangs under the bodywork. i used a leather glove and a bic lighter to heat up and smooth the cut edge.
i cut out a bracket - spacings may vary depending on your states plate and the location & size of the turn signals used.
i cut out a hole in the fender & cut the licence plate light out of the removed section & mounted it.
seen from the bottom ( freshly washed )
mount the bracket
mounted the turn signals and plate
and at night
tim
Comment