Announcement

Collapse
No announcement yet.

Where is the Air/Fuel mixture know on 01 Katana 600

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Where is the Air/Fuel mixture know on 01 Katana 600

    Where is the AF mixture knob located on 01 Katana 600?
    2001 GSX600F Katana Yellow

  • #2
    Same place as the pre Kat, bottom front of the carb, may have a cap pressed over it. Carefully drill and remove the cap.
    "I'm sorry, I didn't mean to upset you when I called you stupid. I thought you already knew..."
    spammer police
    USAF veteran
    If your a veteran, join the KR veterans group

    Comment


    • #3
      Originally posted by 92xjunker View Post
      Carefully drill and remove the cap.
      CAREFULLY! ask me how I know...
      They are thin and drill fast and the plug on the other side is soft material.
      Hope you dont have to deal with them.

      Comment


      • #4
        For optimal off idle response and better a/f mix on most katanas the mixture screws should be set around 2.25-2.5 turns out for a completely stock bike or one with slip on exhaust. With Ivan's kit, 3.5 to 4 turns. Because the Katana is oil cooled, that mixture must be a little richer than a water cooled bike because it takes more to keep engine temps down on our bikes (our bikes get hotter faster) verses one that uses coolant. I have a 2004 600 and when i was running only a slip on (everything else stock) i set the screws to 2.5 turns. Once I got the Ivans kit, screws went to 4 turns. Difference is night & day with the Ivans kit. Just saying.

        Comment


        • #5
          He's correct. However, ONLY go to 4 turns out with an Ivan's jet kit. With a stock set up, Factory Pro, or DynoJunk, go to 2.5 turns out. It's critical.
          Originally posted by clevelandmanwhore View Post
          For optimal off idle response and better a/f mix on most katanas the mixture screws should be set around 2.25-2.5 turns out for a completely stock bike or one with slip on exhaust. With Ivan's kit, 3.5 to 4 turns. Because the Katana is oil cooled, that mixture must be a little richer than a water cooled bike because it takes more to keep engine temps down on our bikes (our bikes get hotter faster) verses one that uses coolant. I have a 2004 600 and when i was running only a slip on (everything else stock) i set the screws to 2.5 turns. Once I got the Ivans kit, screws went to 4 turns. Difference is night & day with the Ivans kit. Just saying.

          Comment

          Working...
          X