If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have some carbon fiber sheets coming to me and I want to put it around my instrument cluster. Is there a place to print off a template or if anyone has done this and has a better idea, man I am all ears
thanks
Hmm thats a one shot deal.
I would feel best making one myself.
Start by cutting some thin paper
with the guage openings.
Three pieces, (or four whatever)
Center those over the gauges and trim
them to the cluster edge adding about 1/2 inch.
Trim /tape them together so now you
have one piece with all the gauge holes aligned.
now little by little trim the extra 1/2 inch back untill the template falls just right.
Use the template to make a thin cardboard test piece.
(using the back to a pad of paper for example)
Check this for fit..
together.
Comment