If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Whats the best method to remove the rust, sand blast or or can the headers from a 98 600 kat fit a 89 600 kat if so any mods that need to be done ?
Get Rich or Die Tryin
SOLD....1989 Red Katana 600
Mesh Mod
K&N Filters
Chrome Decal Kit
Red & Black Gel Grips ( Pro Grip model 724 )
K&S black Bar Ends
Sportech Chrome Windshield
Vance & Hines Supersport Exhaust
Clear flush signals (front)
You can sand blast them. I did that with a set I had on my bike before getting a V&H SS2R system. Just make sure if you paint them to use Hi-tem paint like engine paint. Just becareful that they are not rusted all the way thru in places.
Blast them or wire brush them. i wire brushed my car headers and painted them blck with a high temp engine paint. make sure you get the high heat stuff. I think i bought duplicolor or something like that. Speaking of which It is almost time for new headers on my car... hmmm the bike might have to wait..
"That whenever any form of government becomes destructive to these ends, it is the right of the people to alter or to abolish it, and to institute new government, laying its foundation on such principles and organizing its powers in such form, as to them shall seem most likely to effect their safety and happiness." - Declaration of Independance
I saw the paint that can be used OVER rust ( I think it was Por-15) , but it won't be good for exhasuts . Won't stand too high a temp. (I asked them) . I've heard naval jelly gets rid of rust , and I've played with it on m,y headers . It does eat rust , but seems a mojor pain on LOTS of rust (like mine) . So I guess it's pretty much sand or sandblast .
I am a fluffy lil cuddly lovable bunny , dammit !
Katrider's rally 2011 - md86
Comment