So I had to pull my plastics off my 02 600 to take off the carbs and install a jet kit. I figured I'd repair some damage done by the previous owner due to a lay down. There was some gouges and minor scrapes mainly on the right side of the bike. I removed the factory decals on both sides and repaired the damage.
My Kat is yellow. The plan is to primer over the repairs then lay out some stripes or a design and paint that a matte black. I was just going to rattle can the black to keep cost down.
I was wondering if anybody out there had done something like this before? If so how did it turn out?
Also should I spray some clear over the black or just leave it? I'm not worried about gas getting on it since it's on the side plastics.
My Kat is yellow. The plan is to primer over the repairs then lay out some stripes or a design and paint that a matte black. I was just going to rattle can the black to keep cost down.
I was wondering if anybody out there had done something like this before? If so how did it turn out?
Also should I spray some clear over the black or just leave it? I'm not worried about gas getting on it since it's on the side plastics.