Tweet
I have had a few PM messages about my front turn signals,Thanks for all the compliments 
Just a few thoughts to those who were considering trying it.
Mine have a solid inner core so drainage is an important factor.I drilled two small holes in each one and put in small plastic inserts and ran flexable hose down past the header.You wouldnt want water drainage streaming right on your header, a steamy problem that might be ...lol For my signal lights i used some very nice bright LEDs that had a "pop in" mounting bezels.I epoxied the bezles in.That way you can replace the auctual LEDs if they ever fail.
Finally the mesh outer covers were sealed with some black RV silicone with two small screws holding each one in place.
Well there you have it if you were interested.
Just a few thoughts to those who were considering trying it.Mine have a solid inner core so drainage is an important factor.I drilled two small holes in each one and put in small plastic inserts and ran flexable hose down past the header.You wouldnt want water drainage streaming right on your header, a steamy problem that might be ...lol For my signal lights i used some very nice bright LEDs that had a "pop in" mounting bezels.I epoxied the bezles in.That way you can replace the auctual LEDs if they ever fail.
Finally the mesh outer covers were sealed with some black RV silicone with two small screws holding each one in place.
Well there you have it if you were interested.
Comment