Well I did it. I just wanted to give it a shot and It cames out 10x better then I thought. It took 2 tries but I got it done and done right. At first I use Locktite constrution grade crap and tried liquid nail. IMO they sux. Locktite doesn't hold the mesh in place very well and the liquid nail when it is cured and still it very soft. This is IMO maybe I grabbed the wrong type of this brand but Below is what I found works great and I know will last.
For anyone doing this. I use JB weld to get the mesh held in place just put some on each corner I let it cure I got the 5 mins set-up time. Then I got red RTV and laid a nice bead around the whole mesh. And let it set.
I love it cuz you dont even notices it till you get around 5-10 ft from the bike. And even in the 2nd shot Im probably 6ft away and it is still blurry
Edit: 04/22/2008 I took the Fairing off today becuz my LED's quit works and I figure I work took of some of the inside and the tools I used:
Not bad. It held really good
The JB Weld ran alot more then I wanted too but who cares. The hole is for the Frame Slider
I couldn't post the JB becuz I used it all. But I use Red RTV, The middle tools is a RTV squeezer really make the RTV smooth. And then Sheet Metal cutter.
See how much Mesh I have left over it the sheet is folded over.
For anyone doing this. I use JB weld to get the mesh held in place just put some on each corner I let it cure I got the 5 mins set-up time. Then I got red RTV and laid a nice bead around the whole mesh. And let it set.
I love it cuz you dont even notices it till you get around 5-10 ft from the bike. And even in the 2nd shot Im probably 6ft away and it is still blurry
Edit: 04/22/2008 I took the Fairing off today becuz my LED's quit works and I figure I work took of some of the inside and the tools I used:
Not bad. It held really good
The JB Weld ran alot more then I wanted too but who cares. The hole is for the Frame Slider
I couldn't post the JB becuz I used it all. But I use Red RTV, The middle tools is a RTV squeezer really make the RTV smooth. And then Sheet Metal cutter.
See how much Mesh I have left over it the sheet is folded over.
Comment