I got everything tore down (first time I've attempted this) and installed the speedo and tach gauge no problem. The fuel gauge is giving me a problem. The new gauge face will not slip over the needle due to the needle extending beyond the round piece in the middle (I hope that makes sense). The speedo and tach needles don't do this and the gauges slipped right over. I really don't want to remove the needle. Can I take a dremel tool and cut off a small piece of the needle that goes beyond the round piece? It's not the end of the needle that points to Full or Empty.
Also, I purchased the LED bulbs that someone else here mentioned. They will not snap into the bases off of my gauge cluster. The stock bulbs kind of snap into place. The LEDs won't snap in and are too loose. I'm afraid they will vibrate out.
Other than these two small issues, this is really pretty easy to do.
Thanks.
Also, I purchased the LED bulbs that someone else here mentioned. They will not snap into the bases off of my gauge cluster. The stock bulbs kind of snap into place. The LEDs won't snap in and are too loose. I'm afraid they will vibrate out.
Other than these two small issues, this is really pretty easy to do.
Thanks.
Comment