Hey guys, I've been working on my new '94 Kat 600 project, and I think I have a problem with the rear wheel alignment. The chain run is off to the outside, so I'm not sure if the swingarm is bent out to the left, if the previous owner used the wrong axle spacers, etc. It also seems like the sprocket drive on my wheel is too close to the swingarm to be right. Like you could just slip a piece of paper between there and the sprocket bolts! No contact is evident though, and the wheel turns freely.
So.... I was wondering if anyone could give me a pic fron the rear of the bike showing along the chain run, and maybe a close-up of where the swingarm and sprocket-drive meet. Basically, I'd like to compare the pics to my bike to see if the swingarm is the issue, or the wheel spacers, or maybe something else I'm not aware of without seeing how it's supposed to look.
Also, if anyone has the width measurements on the rear wheel spacers, that info might be helpful for telling if mine aren't the right ones.
Thanks in advance for any help!
So.... I was wondering if anyone could give me a pic fron the rear of the bike showing along the chain run, and maybe a close-up of where the swingarm and sprocket-drive meet. Basically, I'd like to compare the pics to my bike to see if the swingarm is the issue, or the wheel spacers, or maybe something else I'm not aware of without seeing how it's supposed to look.
Also, if anyone has the width measurements on the rear wheel spacers, that info might be helpful for telling if mine aren't the right ones.
Thanks in advance for any help!
Comment