Another case of I know how it was before I took it apart, but that way doesn't match up with the pictures in the Hayne's manual. The pedal side is not the issue. It's the other end which slides onto the splined rod going into the trans.
When I disassembled it, the linkage was pushed ALL the way onto the splines, up against the clutch cover, so that there were exposed splines hanging out the end.
The Haynes manual picture shows the linkage flush with the end of the splined rod (which actually makes more sense to me).
While I'd imagine either way would work fine as long as the retaining bolt is secure... Which is the *correct* way?
Thanks again!
When I disassembled it, the linkage was pushed ALL the way onto the splines, up against the clutch cover, so that there were exposed splines hanging out the end.
The Haynes manual picture shows the linkage flush with the end of the splined rod (which actually makes more sense to me).
While I'd imagine either way would work fine as long as the retaining bolt is secure... Which is the *correct* way?
Thanks again!
Comment