Need advice not really mechanical.
So i am rewiring my beck end. Previous owner did a fender removal but just cut the tail light out. Last year i had a terrible LED plate light install with speakers wire. So now im doing it right and using bullet connectors (The good ones with the removable plastic hood) But i need to make two new holes in the rear fender to run them. So what’s the best way to do that? Standard drill?
So i am rewiring my beck end. Previous owner did a fender removal but just cut the tail light out. Last year i had a terrible LED plate light install with speakers wire. So now im doing it right and using bullet connectors (The good ones with the removable plastic hood) But i need to make two new holes in the rear fender to run them. So what’s the best way to do that? Standard drill?
Comment