'93 Kat 750
So I bought a set of four carbs used from a scrapped 93 kat 750. I was adjusting the float height on carb #1 to 15mm and I noticed that one of the floats in the pair was .5mm lower from the gasket surface. So my QUESTION is "What do i set them too?,,,,Common sense tells me to set one to 15.25mm which would leave the other one at 14.75mm,,,,Or should I just yank a set of floats out of my other carbs,,,,,,
Any suggestions or suggestions appreciated
So I bought a set of four carbs used from a scrapped 93 kat 750. I was adjusting the float height on carb #1 to 15mm and I noticed that one of the floats in the pair was .5mm lower from the gasket surface. So my QUESTION is "What do i set them too?,,,,Common sense tells me to set one to 15.25mm which would leave the other one at 14.75mm,,,,Or should I just yank a set of floats out of my other carbs,,,,,,
Any suggestions or suggestions appreciated
Comment