Gauges don't work after work on ignition...Help

[Ulshy55]

Ok, well i had to take out my ignition in order to make a new key because i lost mine. The only wires i messed with were the ones that attatch to the ignition. And all i did with those was disconnect the wire harness and then reconnect it once i was done. Now my gauges do not work. My rpm and mph gauges do not work. Anyone have any ideas on what i may have messed up?

[Black_peter]

Do the lights work? You may have dislodged another connector under the tank pulling the ignition.

Now that you have your key you can lift the tank...

[Ulshy55]

I know the front and side lights work, and the guage lights work(neutral light etc....) So i guess iu'll take off the tank nad see if i pulled out some wires.

[Black_peter]

on the pre 98s all the wires come in together..
Lights and tach signal. But 98 with the electronic speedo might have two plugs.

[Jax]

Check all the plugs on the gauges...also disconnect the ignition again and inspect the pins on both sides of the connectors...I just rewired my ignition, pre98, and now it works great...

[paradoxmd]

Man, you're not having much luck with the bike are you? I'm telling you, sell it and buy a pre98.

[Black_peter]

Once again... Pre 98s posting...

[paradoxmd]

Once again... Pre 98s posting...

It's an exclusive club. Though my posts in this thread were meaningless and not helpful...come to think of it, most of my posts are that way.

[Black_peter]

Once again... Pre 98s posting...

It's an exclusive club. Though my posts in this thread were meaningless and not helpful...come to think of it, most of my posts are that way.

Yeah.. We've been meaning to talk to you about that..