Another Carb / Float ???????

[c_optic]

'93 Kat 750
So I bought a set of four carbs used from a scrapped 93 kat 750. I was adjusting the float height on carb #1 to 15mm and I noticed that one of the floats in the pair was .5mm lower from the gasket surface. So my QUESTION is "What do i set them too?,,,,Common sense tells me to set one to 15.25mm which would leave the other one at 14.75mm,,,,Or should I just yank a set of floats out of my other carbs,,,,,,
Any suggestions or suggestions appreciated

[Wild-Bill]

If the float bracket isn't completely seated then it will rock side to side a little. The stock specification is 14.7mm +- 1 mm so even if one is 14.95 and the other is set to 14.45 you're just fine.