Well, Corey and I went to turn over the 1127 engine today, and it was a no go. We cranked it by hand, and it felt as if something was stopping it. We pullled the valve cover off, and thought that maybe one of the cams was way outa wack. That wasn't it, so we went even further and pulled off the whole head. Lone and Behold there was something in Cylinder #4. Any one know what it is? I kinda gouged the piston head a bit, no sharp edges or burs, but did mark it up. Here are the pics.
*Note, the Measurement is in CM there, not Inches
Corey thought that maybe it was part of a Bore feeler to measure something. I dunno. I am sure he will chime in here.
*Note, the Measurement is in CM there, not Inches
Corey thought that maybe it was part of a Bore feeler to measure something. I dunno. I am sure he will chime in here.
Comment