I just read the Removing fairings and cowl thread in the FAQ which is great and i couldn't reply there so i had to post here with my question.
I removed the fairing last week with no problems except when reinstalling it i couldn't work out how to set the rubber grommet/washer or whatever into the front of the fairing next to the windshield.
I had to try and pull it out of the fairing bolt hole with a sharp screwdriver turning it around the hole that wasn't easy and this took more time to do than any of the process involved of removing or installing the fairing.
Looking at the picture also it shows these rubbers on the headlight cover that mine doesn't have which i am guessing now it should have.
Any easy way of pulling the rubber back through or pushing it back in or whatever am doing wrong???
IO can post a pic if required if i have lost you all
Nick
I removed the fairing last week with no problems except when reinstalling it i couldn't work out how to set the rubber grommet/washer or whatever into the front of the fairing next to the windshield.
I had to try and pull it out of the fairing bolt hole with a sharp screwdriver turning it around the hole that wasn't easy and this took more time to do than any of the process involved of removing or installing the fairing.
Looking at the picture also it shows these rubbers on the headlight cover that mine doesn't have which i am guessing now it should have.
Any easy way of pulling the rubber back through or pushing it back in or whatever am doing wrong???
IO can post a pic if required if i have lost you all
Nick
Comment