I posted a question along with my introduction and it was suggested that this was probably a better location for the question.
Paula Selvidge of MotorcycleAnchor suggested that maybe someone here may be able to answer the question. They were unable to answer it due to the death of Marc Glasgow (aka. the Cyberpoet). The following is a copy of the message I sent to MotorcycleAnchor:
Approximately 2 years ago I installed a pair of the "Billet Tire Valves" (http://www.motorcycleanchor.com/tire_valves/index.htm) in the wheels of my 1996 Honda Pacific Coast (PC 800). I positioned them pointing to the left side of the bike due to the stub on the rim for the valve stem support, but I would now like to reposition them pointing to the right side as I feel it will be easier to check pressure on the rear tire with the bike leaned on the side stand. I am ready to mount a new rear tire therefore I will be able to get to the nut on the "Billet Tire Valve". My question is will the "rubber gasket" reseal if I loosen the "paired nut" on the valve body and rotate the valve 180 degrees and retighten the "paired nut" or will I need a new rubber gasket. I am aware I will have to cut the stub from the rim so the "Billet Tire Valves" will seat correctly, this will not effect the sealing surface.
Any assistance anyone can provide will be greatly appreciated. Thanks for your time.
Ride Safe!!!! Mac H.
Paula Selvidge of MotorcycleAnchor suggested that maybe someone here may be able to answer the question. They were unable to answer it due to the death of Marc Glasgow (aka. the Cyberpoet). The following is a copy of the message I sent to MotorcycleAnchor:
Approximately 2 years ago I installed a pair of the "Billet Tire Valves" (http://www.motorcycleanchor.com/tire_valves/index.htm) in the wheels of my 1996 Honda Pacific Coast (PC 800). I positioned them pointing to the left side of the bike due to the stub on the rim for the valve stem support, but I would now like to reposition them pointing to the right side as I feel it will be easier to check pressure on the rear tire with the bike leaned on the side stand. I am ready to mount a new rear tire therefore I will be able to get to the nut on the "Billet Tire Valve". My question is will the "rubber gasket" reseal if I loosen the "paired nut" on the valve body and rotate the valve 180 degrees and retighten the "paired nut" or will I need a new rubber gasket. I am aware I will have to cut the stub from the rim so the "Billet Tire Valves" will seat correctly, this will not effect the sealing surface.
Any assistance anyone can provide will be greatly appreciated. Thanks for your time.
Ride Safe!!!! Mac H.
Comment