Thats right. Got her fired up yesterday after installing the Factory Pro (wasnt sure how it ran prior) and cylinder 2's header pipe was no where near as hot as the rest. Today, suspecting a bad plug or bad cable (cause i KNEW the carbs are clean) I swapped the plugs from 2 to 4 and all of a sudden it idled pretty normal. Still a little twitchy but I think a sync will fix that. I even took it down the street and it SCREAMS!!
So what do you think happened? I def made sure the wires were firm on the plugs yesterday so its not like i did that wrong. You think maybe the wire on plug #2 is just sketchy? That ever happen?
Not sure I'm trusting it too much right now but we'll see after I replace the plugs and wires.
FYI- Factory Pro needles 3rd clip down, pilot screws 2.5 out, floats 14mm, 112.5 mains.
So what do you think happened? I def made sure the wires were firm on the plugs yesterday so its not like i did that wrong. You think maybe the wire on plug #2 is just sketchy? That ever happen?
Not sure I'm trusting it too much right now but we'll see after I replace the plugs and wires.
FYI- Factory Pro needles 3rd clip down, pilot screws 2.5 out, floats 14mm, 112.5 mains.
Comment