Looking for everyone's opinion on the setup of their fp setups. I got a set of headers and a vance mid pipe and can any trial and errors?
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
FP install sheet covers exactly your setup. Stock setup on the jets, 2.5 turns on mixture, third clips up on the needle, as a starting point."I'm sorry, I didn't mean to upset you when I called you stupid. I thought you already knew..."
spammer police
USAF veteran
If your a veteran, join the KR veterans group
-
Originally posted by arsenic View PostWhat bike do you have a 90-97 600? If so I'm not so sure the 112.5 main jets will be the best. Test the 112.5 and the 115. Choose the one that pulls the best at wide open throttle.
Ya I got a 96 600 but wasn't sure glad you measaged arsenic when you do a rebuild with the kit in what do you install?
Comment
-
Ya see I have her all ripped apart gotta do the valves and clean it up so was hoping to get some one who installed these so I could take their opinions and just install from there I know there will be some tweeking but didn't wanna have to rip the carbs apart again
Comment
-
I ran the FP stage 1 kit, 115 main jets, needle was on the 3rd clip and A/F scows were around 3 turns. I noticed I had to adjust the A/F screws depending on season as in NJ the temps would go from 40's to 100's from spring to winter. Most of the time I went from 2.5 turns in the summer hot months and 3 turns when it was cooler out.
I had a the FP stage 1, V&H full exhaust, timing advanced 4* for about a year, then I turbo'd it and kept the FP jet kit installed but swapped out the jets for something a bit smaller.1990 TURBO Kat 600 G15 hidden turbo 12psi
fender eliminator w/led integrated tail light
55w dual HID bixenon projector w/halo, blue lighting
R6 shock, Custom billet mirrors, oil temp/boost gauges
Post rim swap 170/120 tires, EBC pads/rotors, G&J lines
Comment
Comment