Just got my new axle I ordered from Jim Matherly of Radical Engineering in Summerfield NC.
It's a 350mm long, 17mm diam, with 26mm of theads at 5/8 - 18 on each end. This will be the axle for the swingarm modification to fit a GSXR 750 and 180-190 tire on the back of a 93 750 Kat using the stock swingarm as the starting point.
I can't say enough about how quick and easy Mr. Matherly made getting this. Very helpful in offering advice and quick turn around. Great comunication and quick responses. Arrived less than 5 days after ordering it. Cost me $42 shipped to my door. Arrived very well packaged with bubble wrap and a nice note to add cotter pins or use loctite to be safe.
Just thought I would share my experiance, and say I highly recomend him if your needing any machined parts. I'll be using his services in the future for sure.
BTW, found him on Ebay and he does accept paypal.
Krey
It's a 350mm long, 17mm diam, with 26mm of theads at 5/8 - 18 on each end. This will be the axle for the swingarm modification to fit a GSXR 750 and 180-190 tire on the back of a 93 750 Kat using the stock swingarm as the starting point.
I can't say enough about how quick and easy Mr. Matherly made getting this. Very helpful in offering advice and quick turn around. Great comunication and quick responses. Arrived less than 5 days after ordering it. Cost me $42 shipped to my door. Arrived very well packaged with bubble wrap and a nice note to add cotter pins or use loctite to be safe.
Just thought I would share my experiance, and say I highly recomend him if your needing any machined parts. I'll be using his services in the future for sure.
BTW, found him on Ebay and he does accept paypal.
Krey
Comment