If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yup, mr. croom is a freaking genius. You on KF? I'm scottynoface on their as well.
90% of motorcycle forum members do not have a service manual for their bike.
Originally posted by Badfaerie
I love how the most ignorant people I have met are the ones that fling the word "ignorant" around like it's an insult, or poo. Maybe they think it means poo
Originally posted by soulless kaos
but personaly I dont see a point in a 1000 you can get the same power from a properly tuned 600 with less weight and better handeling.
Ah gotcha. Yeah, KF is full of a lot of...well...yeah you know
90% of motorcycle forum members do not have a service manual for their bike.
Originally posted by Badfaerie
I love how the most ignorant people I have met are the ones that fling the word "ignorant" around like it's an insult, or poo. Maybe they think it means poo
Originally posted by soulless kaos
but personaly I dont see a point in a 1000 you can get the same power from a properly tuned 600 with less weight and better handeling.
That's a nice looking little tool Cyber, and about the right size to fit under the seat.
Pics Pics
No pics yet
Just because they sound the same doesn't mean they are: there≠their≠they're; to≠too≠two; its≠it's; your≠you're; know≠no; brake≠break
Pics Pics
No pics yet
Just because they sound the same doesn't mean they are: there≠their≠they're; to≠too≠two; its≠it's; your≠you're; know≠no; brake≠break
Is it for flaring the rivet only or for also breaking the chain also(pushing the pin out after grinding off the rivet head)?
Have you used this yourself or gotten any feedback from those who have?
It will push out the pin once ground down, and will push the plate down as well. It won't cut the rivet-head off.
It works (I've used one), and there are quite a few KR members who scored them over the past 6 months that I've been offering it, so you can ask around about their opinions. It's an exact clone of DID's $150 KM500 tool
The flaring point is not wide enough to mushroom then link properly
besides a cheap clamp will break before that rivit is properly installed
use the proper tool
Comment