Here's a print out of what I recently did on a set of carbs for an early Kat:
44C10 Mikuni Carbs
Assembled from clean stripped carcasses
Cleaned and lubed choke plungers
Installed brand new rubber boots at fuel tees
Installed fuel tees and breather tees
Installed both positioning bars and all screws
Installed all springs for throttle mechanisms
Installed brand new Large O-rings at bottom of Air Slide Chambers
Installed brand new Large O-rings at floats
Installed brand new Small O-rings at floats
Installed brand new rubber stopper plugs at pilot jets
Installed adjustable needles with clips at needles to position # 3
Installed all correct needle hardware
Installed pilot jets (32.5)
Installed brand new bowl gaskets
Installed brand new 120 Main Jets
Installed all screws at caps and bowls
Installed clips top & bottom
Cleaned out/blew out enricher circuits in floats
Checked float needles and seats - OK
Set float heights to 14.6mm
Set Air/Fuel mix screws to 1.5 turns out from stop
Checked emulsion tubes for roundness vs. egg shaped – OK
Checked needles for wear – OK
Checked air diaphragms for wear or cracks – OK
Installed rubber vacuum boots and slides
Installed vacuum slide springs
Installed brand new small O-rings at air tops for vacuum ports
Checked choke rods & slide bar for smooth operation–OK (one clip
missing)
Two caps missing
Installed brand new fuel hoses and clips top & bottom
Installed idle adjuster rod/cable
Reset butterfly valves (adjusted) by sight – ˝ first hole showing
Checked air slides for smooth operation and vacuum suck - OK
This should provide a good check list for several of you.
44C10 Mikuni Carbs
Assembled from clean stripped carcasses
Cleaned and lubed choke plungers
Installed brand new rubber boots at fuel tees
Installed fuel tees and breather tees
Installed both positioning bars and all screws
Installed all springs for throttle mechanisms
Installed brand new Large O-rings at bottom of Air Slide Chambers
Installed brand new Large O-rings at floats
Installed brand new Small O-rings at floats
Installed brand new rubber stopper plugs at pilot jets
Installed adjustable needles with clips at needles to position # 3
Installed all correct needle hardware
Installed pilot jets (32.5)
Installed brand new bowl gaskets
Installed brand new 120 Main Jets
Installed all screws at caps and bowls
Installed clips top & bottom
Cleaned out/blew out enricher circuits in floats
Checked float needles and seats - OK
Set float heights to 14.6mm
Set Air/Fuel mix screws to 1.5 turns out from stop
Checked emulsion tubes for roundness vs. egg shaped – OK
Checked needles for wear – OK
Checked air diaphragms for wear or cracks – OK
Installed rubber vacuum boots and slides
Installed vacuum slide springs
Installed brand new small O-rings at air tops for vacuum ports
Checked choke rods & slide bar for smooth operation–OK (one clip
missing)
Two caps missing
Installed brand new fuel hoses and clips top & bottom
Installed idle adjuster rod/cable
Reset butterfly valves (adjusted) by sight – ˝ first hole showing
Checked air slides for smooth operation and vacuum suck - OK
This should provide a good check list for several of you.
Comment