Tweet
So I was looking to adjust my afr screw, but for some reason mine is just a flat piece of metal. Am I missing something? https://ibb.co/eNifP5
-
-
Those get drilled out. Check out carbs 101 and 102 in the maintence section for more info -
That's just a thin metal insert, so be careful when you drill to not hit the screws underneath. Drill a small hole, thread in a tap screw, pull the cover plate off.
Krey93 750 Kat
Modified Swingarm, 5.5 GSXR Rear with 180/55 and 520 Chain, 750 to 600 Tail conversion, more to come. Long Term Project build thread http://katriders.com/vb/showthread.php?t=96736
"I've done this a thousand times before. What could possibly go wron.... Ooops!"Comment
-
Awesome, thanksComment
-
I was wondering the same. Not for the plug but setting the screw
to put back what the EPA has taken away. The manual is showing
1 7/8 turns out and that seems pretty juicy at least comparing to the
CV40's I've done in the past. This bank of carbs is my first Mikuni's
so I hope they are close. Stock intake and farter. Should I go two turns?
(630 ft ASL)
CheapMarkComment
-
US spec bike? 2.5 is recommended.1998 Katana 750
1992 Katana 1100
2006 Ninja 250
2006 Katana 600 RIP - 130k milesComment
-
Thanks!
(and working my way to 15 posts
to put up pics of the blue/ silver tunafish.)Comment
Comment