Tweet
Alright, so a few days ago i posted a thread about having no clutch pressure and i figured out that it was the nut and washers that hold the clutch plates together inside the clutch casing. well last night while on a ride with a few other bikes, i ran into the same issue...i can only think that it is the same thing happening once again. does anyone know how i can tighten the nut around the clutch plate bolt ? how tight does it have to be? and does anyone know what size nut it actually is ? and last but not least, has anyone else ran into this problem and if so, how did you fix it? thanks everyone!
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
.
Working...
Comment