hooked on phonics werked fer me!
Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
X
-
Originally posted by etskatana View Post140/80-17= 25.82
120/70-17= 23.61
sorry i didnt have the time to right all the calculations but hope it helps
Each tire company will have different specs for the same size tire. Check out the spec on my dunlop qualifier on dunlop's website, here is the link:
It actually measures 23.80", which would be a difference of more than 3/16". May not be much but there can be a little difference in calculating it that way.
But anyway.... I have my stuff at powdercoat and once I get to set the forks back on I will set it back to the original angle.
I'll repost to let everyone know if I can notice any changes. I'll try some small adjustments before hitting those curves to hard.Scuffin' the pucks!
Comment
-
Originally posted by dcc5266 View PostSo my front tire should be 23.61" in diameter. I agree with how you get the calculations but that doesn't give you an accurate measure.
Each tire company will have different specs for the same size tire. Check out the spec on my dunlop qualifier on dunlop's website, here is the link:
It actually measures 23.80", which would be a difference of more than 3/16". May not be much but there can be a little difference in calculating it that way.
But anyway.... I have my stuff at powdercoat and once I get to set the forks back on I will set it back to the original angle.
I'll repost to let everyone know if I can notice any changes. I'll try some small adjustments before hitting those curves to hard.
Comment
-
Hey! Just got my wheels, fork tubes, and swingarm back from powdercoat. One little spot on one of the wheels. Other than that, everthing looks good! Check out my pics!
Scuffin' the pucks!
Comment
-
Originally posted by dcc5266 View PostHey! Just got my wheels, fork tubes, and swingarm back from powdercoat. One little spot on one of the wheels. Other than that, everthing looks good! Check out my pics!
http://s569.photobucket.com/albums/ss133/dcc5266/
Comment
-
-
Very generally, no bike that is expected to take an aggressive corner should have a rake greater then 105 degrees. Under suppressional load in a corner anything more upwrite will have a tendency to washout the front wheel especially if hitting the front brakes when the bike is over in an extreme angle.
The rake measurement can be changed by either dropping the tree through the forks or even more dramatically, raising the rear. The forks will naturally slide forward if dropping the front; where as the front axle will be a pivot point if lifting the rear via dogbones or minor w a rear tire change. Especially when dropping the front more weight will be on the front handlebars for those that take corners w cross steering or hands vs riders that ride w their legs. Its a matter of preference and ground clearance. A good safe rule of thumb is to not slide forks of any bike over 1 inch past oem setting when dropping the front; consider fork springs when going lower.
Comment
Comment