I got the original speedo for the bike in parts box and it was in pieces. Two pictures are attached. From the main plug I put a white wire in the socket that was broken off even with the plug, enough to identify a white wire went there.
Three gray wires (with white at bulb) connected to gray from plug. Those look to be main lighting at top and each side. I got the distance sensor wires plugged in.
Brown, white and orange from top rear of speedo. Does the orange and white tie into same circut as the orange and white coming out of plug?
I have all white wires connected to wire from plug and tied in white from top rear to those wires. Can't see where else this could go by diagram I have.
Orange, yellow,blue,black look pretty straight forward Got a few more parts on order, mounting cushions for top of bracket, a few bulbs, gasket seal kit, face plate and a trip meter knob.
Haven't put power to it yet, just wondered if anyone familiar with a rebuild on these notices any issues with the way it's wired. Can't beat experience
I can't see any pictures from my computer so I hope they show up.
Thanks
Three gray wires (with white at bulb) connected to gray from plug. Those look to be main lighting at top and each side. I got the distance sensor wires plugged in.
Brown, white and orange from top rear of speedo. Does the orange and white tie into same circut as the orange and white coming out of plug?
I have all white wires connected to wire from plug and tied in white from top rear to those wires. Can't see where else this could go by diagram I have.
Orange, yellow,blue,black look pretty straight forward Got a few more parts on order, mounting cushions for top of bracket, a few bulbs, gasket seal kit, face plate and a trip meter knob.
Haven't put power to it yet, just wondered if anyone familiar with a rebuild on these notices any issues with the way it's wired. Can't beat experience
I can't see any pictures from my computer so I hope they show up.
Thanks
Comment