Hi everyone,
I have a 2000 Katana 750 with aftermarket exhaust and Factory Pro Jet kit installed. About three months ago I removed the carburetor bank for cleaning which I have done many times in the past with no issue. Cleaned everything as usual and meticulously replaced each and every o-ring, spring, jet, etc. Put the carbs back on and now I have the following issue:
At approximately 3k RPM with just a small amount of throttle in order to maintain speed (slow speed cruising) the engine studders and runs rough. Once I top about 4500 RPM it smooths out. When Im accelerating hard it runs perferctly. It idles perfectly.
-I have checked, rechecked, and checked again jets, emulsion tubes, needle height, and float height. Float height is at 10mm but this has always been the level and ran perfectly before.
-All hoses have been checked.
-Fuel filter has been checked - clear.
-Fuel intake boots have been removed, the gaskets replaced, and checked for leaks afterward. No leaks.
-The connections between the carbs and manifold boots have also been checked for air leaks. None.
-The slide diaphragms are intact and in excellent condition with no tears. Also the O rings along the gasket of the 'caps' are intact as well.
Anyone have any ideas? Im at the point to where Im ready to just purchase another bank of carburetors.
I have a 2000 Katana 750 with aftermarket exhaust and Factory Pro Jet kit installed. About three months ago I removed the carburetor bank for cleaning which I have done many times in the past with no issue. Cleaned everything as usual and meticulously replaced each and every o-ring, spring, jet, etc. Put the carbs back on and now I have the following issue:
At approximately 3k RPM with just a small amount of throttle in order to maintain speed (slow speed cruising) the engine studders and runs rough. Once I top about 4500 RPM it smooths out. When Im accelerating hard it runs perferctly. It idles perfectly.
-I have checked, rechecked, and checked again jets, emulsion tubes, needle height, and float height. Float height is at 10mm but this has always been the level and ran perfectly before.
-All hoses have been checked.
-Fuel filter has been checked - clear.
-Fuel intake boots have been removed, the gaskets replaced, and checked for leaks afterward. No leaks.
-The connections between the carbs and manifold boots have also been checked for air leaks. None.
-The slide diaphragms are intact and in excellent condition with no tears. Also the O rings along the gasket of the 'caps' are intact as well.
Anyone have any ideas? Im at the point to where Im ready to just purchase another bank of carburetors.
Comment