Well, I was mocking up my shocks and lower mounts to determine the exact placement of the lower mounts. I bolted the upper mounts without an issues until I removed the nuts. The upper mount snapped on the left side and I was even wrenching hard
What would be the best way to fix this? There appears to be enough material to cut with a die and use a thinner nut. Would this be a good idea?
Can these be replaced by grinding the welds w/o much problems? I do not mind getting larger strong bolts welded for the zrx shocks.
Any advice is welcomed.
What would be the best way to fix this? There appears to be enough material to cut with a die and use a thinner nut. Would this be a good idea?
Can these be replaced by grinding the welds w/o much problems? I do not mind getting larger strong bolts welded for the zrx shocks.
Any advice is welcomed.
Comment