I have a 99 katana 600... I am having trouble understanding how to visually sync my carbs.
There is no hole that can be covered by twisting the idle adjustment knob like they describe here:
Can anyone help me with this, or do you have any pics? because I don't see how any hole can possibly be covered by the butterfly valve
EDIT: Nevermind, I just found them. They're so small, almost invisible. I had been trying to figure it out for hours lol
But if someone could answer my question about the float height measuring, it would be greatly appreciated:
Do I measure from #1 or #2 to the carb body?
There is no hole that can be covered by twisting the idle adjustment knob like they describe here:
* Reinstall the idle adjuster cable until it just barely touches the starter tab of the carbs.
Now look into the engine side of the carbs at the butterfly valves. (There are three small
holes – familiarize yourself with them.) Look at carb # 3 and adjust the idle cable until
the first small hole (towards the outside of the carbs) on the bottom of the carbs is HALF
VISIBLE.
Now look into the engine side of the carbs at the butterfly valves. (There are three small
holes – familiarize yourself with them.) Look at carb # 3 and adjust the idle cable until
the first small hole (towards the outside of the carbs) on the bottom of the carbs is HALF
VISIBLE.
EDIT: Nevermind, I just found them. They're so small, almost invisible. I had been trying to figure it out for hours lol
But if someone could answer my question about the float height measuring, it would be greatly appreciated:
Do I measure from #1 or #2 to the carb body?
Comment