PDA

View Full Version : used D & D slip on


jaimzc
04-18-2007, 06:43 AM
I just bought a used D & D slip on off ebay for about $120. The only dilema I might have is with the fact that it came off of an R1, and a gsxr prior to that, but it was too good of a deal to pass up. I'm not sure if this will fit my 2000 kat600 or not, but would it be possible to just use the stock midpipe with the D & D can? Or just cut the midpipe at a different location to make the curve fit? Any suggestions?? Input??

p.s. I guess I could have waited to get the exhaust in my hands before I posted this just in case it fits as-is, but I figured I'd be proactive and ask the pros here on katriders. Very Happy

jeffro7172
04-18-2007, 04:56 PM
my stock stuff is all welded together if I remember right. so I guess in theory you could cut the stock pipe and then make the new can fit it, but it wouldn't look as nice and it might even be a different diameter. Don't know for SURE, but I'd bet someone else will sound off if they know better.

duff daddy
04-18-2007, 07:39 PM
yea the stock one will fit exp that its gonna be wicked loud and super obnoxious if you have a set of -1 +2 sprockets on your bike, i did on my katana and id give anything to have my yoshimura back on that (yes it was the FULL yoshi exhaust)

jaimzc
04-18-2007, 10:43 PM
What are -1 +2 sprockets? Wicked loud is good. I have a dremel with a grinder, so if the R1 midpipe doesn't work I was just going to cut the factory can off and clamp on the D & D